How to remove the engine oil filter cover?

Question

ZAMM - Verified OEM Motorcycle Technical Knowledge Base · Accepted Answer

## Tools Required
- 8 mm socket with ratchet
- Drain tray / catch pan

---

## Removal Procedure

1. **Setup & Preparation:**
   - Park the motorcycle upright on its center stand on a firm, level surface.
   - Place a drain tray directly underneath the right-hand (RH) engine cover.

[!WARNING]
The engine, exhaust pipes, and oil become extremely hot during operation. Allow the engine to cool to a safe temperature before handling components to avoid severe burn injuries.

2. **Remove Cover Bolts:**
   - Using an 8 mm socket with a ratchet, loosen and remove the 3 M6 hex bolts securing the oil filter cover to the RH crankcase cover:
     - 1 long hex flange bolt from the bottom of the cover.
     - 2 shorter hex flange bolts from the top of the cover.

3. **Take Off the Cover:**
   - Gently pull the oil filter cover away from the engine casing along with its sealing O-ring/gasket.
   - Catch any residual engine oil that drains from the cavity into the drain tray.
   - Gently shake and pull the oil filter element out from the cavity.

[!NOTE]
Always inspect the rubber O-ring/gasket for tears, flattening, or hardening, and replace it during reassembly to ensure a proper seal against oil leaks.

How to remove the engine oil filter cover?

Tools Required

Removal Procedure

Information Sources